Quick Manual v2.2 // FMC640
18
This message contains information on how to operate FMC640
safely. By following these requirements and recommendations,
you will avoid dangerous situations. You must read these
instructions carefully and follow them strictly before operating
the device!
• The device uses SELV limited power source. The nominal
voltage is +12 V DC. The allowed voltage range is +10...+30
V DC.
• To avoid mechanical damage, it is advised to transport
the device in an impact-proof package. Before usage,
the device should be placed so that its LED indicators are
visible. They show the status of device operation.
• When connecting the 2x10 connector cables to the
vehicle, the appropriate jumpers of the power supply of
the vehicle should be disconnected.
• Before dismounting the device from the vehicle, the 2x10
connector must be disconnected.
• The device is designed to be mounted in a zone of limited
access, which is inaccessible to the operator. All related
devices must meet the requirements of EN 62368-1
standard.
• The device FMC640 is not designed as a navigational
device for boats.
SAFETY INFORMATION
Do not disassemble the device. If the device is
damaged, the power supply cables are not isolated
or the isolation is damaged, DO NOT touch the
device before unplugging the power supply.
All wireless data transferring devices produce
interference that may aect other devices which are
placed nearby.
The programming must be performed using a PC
with autonomic power supply.
The device must be rmly fastened in a predened
location.
The device must be connected only by qualied
personnel.
Installation and/or handling during a lightning storm
is prohibited.
The device is susceptible to water and humidity.
To Next Page
Loading...
