RUT955 User‘s Manual
Teltonika Solutions
7.7 Routing
7.7.1 Static Routes
Static routes specify over which interface and gateway a certain host or network can be reached. In this page you
can configure your own custom routes.
Defines which table will be used for the route in question
The zone where the target network resides
The address of the destination network
Mask that is applied to the Target to determine to what actual
IP addresses the routing rule applies
Where the router should send all the traffic that applies to the
rule
Used as a sorting measure. If a packet about to be routed fits
two rules, the one with the higher metric is applied
*Additional notes on Destination & Netmask:
You can define a rule that applies to a single IP like this: Destination - some IP; Netmask - 255.255.255.255.
Furthermore, you can define a rule that applies to a segment of IPs like this: Destination – some IP that STARTS the
segment; Netmask – Netmask that defines how large the segment is. e.g.:
Only applies to 192.168.55.161
Applies to IPs in the 192.168.55.0 - 192.168.55.255 range
192.168.55.240 - 192.168.55.255
192.168.55.0 - 192.168.55.255
192.168.0.0 - 192.168.255.255