Note:
Temperatures may uctuate depending on whether the interior light is ON or OFF and
depending on the position of the bottles.
CARE AND MAINTENANCE
CLEANING THE WINE COOLER
•
Turn o the power, unplug the appliance, and remove all items including shelves.
•
Wipe the inside surfaces with a sponge and baking soda solution. The solution should
be about 2 tablespoons of baking soda to 1 quart (approx. 1 litre) of warm water.
•
Wash the shelves with a mild detergent solution. Allow wooden shelves to dry before
placing back into the wine cooler.
•
Wring excess water out of the sponge or cloth when cleaning area of the controls, or
any electrical parts.
•
Wipe the outside cabinet with warm water and mild liquid detergent. Wipe dry with
a clean soft cloth.
•
Do not use steel wool or steel brush on the stainless steel. These will scratch the
stainless steel with steel particles and rusting may occur.
REMOVING THE SHELVES
•
Before removing a Shelf from the appliance, it is necessary to remove all the bottles
on the Shelf ;
•
For a model without Telescopic Rail, move the shelf to the position where the cut
of the wooden shelf is directly under the plastic stopper and lift the wooden shelf.
Please ensure these are replaced when the shelf is put back.
•
Make sure the shelves are fully engaged before loading any bottle into the cabinet.
Pull the shelves out all the way to the STOPPER position and push them back in
several times to make sure the shelves are properly engaged.
BA
A Cut B Plastic Stopper
To Next Page
Loading...