Warning: To avoid damaging the compressor, please do not turn on the
appliance again within 5 minutes after you turn it o.
UNLOCKING THE CONTROL PANEL
•
To unlock the control panel, touch the power mark and lighting mark
with 2 ngers at the same time and hold for 3 seconds . When unlocked a buzz sound
will be heard.
•
The control panel will be automatically locked with a buzz sound heard after 10
seconds without being touched.
•
Under the locked condition, the control panel will not react to any touching order for
Lighting On/O and Temperature Setting.
INTERIOR LIGHTING ON/OFF CONTROL
•
Under the unlocked condition, touch the lighting mark to turn on (or turn o) the
interior cool LED lighting.
•
The lighting will stay on unstil it is manually turned o.
TEMPERATURE DISPLAY WINDOW
•
The temperature is displayed in digital which is the best way to be read out. The
digital is shown as the set temperature when you are setting the temperature, and it
will change to be the real temperature of the inside cabinet after 10 seconds without
being touched.
•
When the temperature probe is out of order, the display window will show with “HH”
or “LL” instead of a digital gure while continuous buzz sound will be heard. In case
of this happens, this appliance is considerately designed to keep periodical running
of compressor and fans which helps to keep the coldness of the inside cabinet to
protect your stored wines.
Warning: To avoid destroying your stored wines, it is strongly recommended
to have the appliance repaired immediately, as the spare periodical running
can not ensure the appliance to achieve the temperature you have set.
TEMPERATURE RANGE SETTING
For Single Zone
•
The default temperature setting range is E: 5-22
ºC
(41-72
ºF
).
•
To set a temperature range as desired, pls.make sure the control panel is under locked
condition.
•
Press the mark for 3 seconds, the display window will ash "E"--"F"--"H"--"L" in
loop with a sound of beep by every pressing.
•
Leave the window ashing for 3 seconds with a sound of beep to conrm the setting.
To Next Page
Loading...