Rev. 00 / 10.02.14
Filling Up Clean Water Tank
3.6 Accessories
Flush system uses water from this
tank. Always ll up the tank with
clean tap water.
1. Clean Water Inlet
2. Inlet Valve
3. By-Pass Valve
4. Level Indicator
5. Thermostat
1.
Connect water supply to clean
water inlet (1).
2. Pull inlet valve (2) upwards.
3. Check water level.
4. Restore inlet valve (2) to its origi-
nal position.
5. Disconnect the water supply.
WARNING
• DO NOT overll the tank.
•
DO NOT add anti-freeze
agents in to the tank.
INFORMATION
If clean water tank is empty,
a fault message displayed on
warning panel.
Lavatory Water Tank
To Next Page
Loading...
