599 / Eagle Users manual Release 1.009 CE – April 15, 2015
Part #74447
Printed in USA 20
2.9. Internal Tuner
The Eagle offers an optional Internal Tuner.
Once the Auto Tuner is installed, you will
need to go into the Configuration Menu and
enable it on.
CAUTION: Please refer to the section
entitled “PROPER TUNER OPERATION”
before utilizing the internal tuner.
The Eagle provides manual tune method,
along with an auto tune/bypass selection.
To change back and forth between manual
tune mode, and auto tune mode, press and
hold the TUNE button for about 3 seconds,
then you will hear a series of beeps. 2 beeps
means that you have the Internal Tuner
placed in bypass mode, and you can now tune
manually. 1 beep means that you have placed
the Internal Tuner in Auto Tune mode, and
you can use it to automatically find a match
internally.
Manual Tune mode is similar to other TenTec
radios, press the TUNE button when in
Manual Tune mode, and that will place the
Eagle into CW Mode, 20 Watts, and then
enable the transmitter.
Auto Tune mode is also similar to other
TenTec radios, press the TUNE button
momentarily when in Auto Tune mode, and it
will start the auto tune process, finding the
best match for the given load on the antenna.
When Auto Tune mode is active, the Eagle is
transmitting 20 watts, just as in Manual Tune
mode.
To Next Page
Loading...
