Tenda AC11 User Manual

96
Step 3 Click the drop-down box of Clone MAC Address, and choose Clone Local Host MAC to
copy the MAC address of the management device, or Manual to enter the desired MAC
address.
Step 4 Click OK on the bottom of the page.
---End
11.2.4 Change the WAN Speed
To access the configuration page, log in to the web UI of the router, and choose Administration >
WAN Parameters.
When the Ethernet cable is not damaged and connected to the WAN port properly, but Ethernet
cable disconnected is still shown on the Internet Settings page, you can try to change the WAN
Speed to 10 Mbps full duplex or 10 Mbps half duplex to solve the problem. Otherwise, keep the
default settings.
MTU parameter description
MTU
Application
1000 Mbps auto-
negotiation
It indicates that the speed and duplex mode are determined through the negotiation
with the peer port.
10 Mbps FDX
10 Mbps Full Duplex. It indicates that the WAN port is working at the speed of 10
Mbps, and the port can receive and send data packets at the same time.

Tenda AC11 Specifications

General

Max WiFi Speed	1200 Mbps
Frequency Bands	2.4 GHz, 5 GHz
RAM	128 MB
MU-MIMO	Yes
WiFi Standard	IEEE 802.11ac
Wireless Standards	IEEE 802.11ac/a/n/g/b
Wireless Speed	300 Mbps (2.4 GHz) + 867 Mbps (5 GHz)
Antennas	5 external antennas
Ports	1 x 10/100Mbps WAN port, 3 x 10/100Mbps LAN ports
Interface	Web-based Interface
Button	WPS/Reset
Security	WPA-PSK/WPA2-PSK
Power Input	100-240V AC, 50/60 Hz