28
Step 6 Enter the password of the selected WiFi network, which is TendaAC947 in this example.
Step 7 Click Connect. The router will reboot to activate the settings.
Step 8 Log in to the web UI of the router again, navigate to Status to ensure that Bridged in
Universal Repeater mode is shown on this page.
The LAN IP address of the router will change. Please log in to the web UI of the router by visiting
tendawifi.com. If there is another network device with the same login domain name (tendawifi.com)
with the router, log in to the upstream router and find the IP address obtained by the new router in the
client list. Then you can log in to the web UI of the router by visiting the IP address.
If the connection between the Upstream Router and My Router failed, try the following solutions:
⚫
Ensure that you have entered the correct WiFi password of the WiFi, and mind case sensitivity.
⚫
Ensure that My Router is within the wireless coverage of the Upstream Router.
Step 9 Relocate the new router by referring to the following suggestions and power it on again:
− Between the original router and the uncovered area, but within the coverage of the
original router.
− Away from the microwave oven, electromagnetic oven, refrigerator.
− Above the ground with few obstacles.
After the new router is set to universal repeater mode, Do NOT connect any device to the WAN port
of the new router.
---End
To Next Page
Loading...
Need help?
General
