Tenda AC11 User Manual

62
Goal: Only allow certain devices of family members to access the internet.
Solution: You can configure the MAC address filter function to reach the goal.
Assume the MAC address and connection status of your domestic devices are as follows.
Device
MAC address
Status
Your own phone
8C:EC:4B:B3:04:92
Connected
Wife’s phone
94:C6:91:29:C2:12
Disconnected
Daughter’s phone
98:9C:57:19:D0:1B
Disconnected
Configuring procedures:
Step 1 Start a web browser on a device connected to the router and visit tendawifi.com to log in
to the web UI of the router.
Step 2 Choose Advanced > MAC Address Filter.
Step 3 Set the Filter Mode to Whitelist.
Step 4 Enter the Whitelisted MAC Address of the device, which is 94:C6:91:29:C2:12 in this
example.
Step 5 (Optional) Enter the remark for the device, which is Wife’s phone in this example.
Step 6 Click .
Step 7 Repeat Step 4 to Step 6 to add Daughter’s phone (98:9C:57:19:D0:1B) to the whitelist.
Step 8 Click OK at the bottom of the page.
---End
When configuration is completed, only the three devices added can access the internet through
the router.

Tenda AC11 Specifications

General

Max WiFi Speed	1200 Mbps
Frequency Bands	2.4 GHz, 5 GHz
RAM	128 MB
MU-MIMO	Yes
WiFi Standard	IEEE 802.11ac
Wireless Standards	IEEE 802.11ac/a/n/g/b
Wireless Speed	300 Mbps (2.4 GHz) + 867 Mbps (5 GHz)
Antennas	5 external antennas
Ports	1 x 10/100Mbps WAN port, 3 x 10/100Mbps LAN ports
Interface	Web-based Interface
Button	WPS/Reset
Security	WPA-PSK/WPA2-PSK
Power Input	100-240V AC, 50/60 Hz