121
After you prepare two steps above, do as follows:
Configure Router 2:
① Set the LAN IP address of Router 2 to a different IP address yet on the same segment as Router 1.
Click Advanced > Advanced Setup > LAN to change the LAN IP address into 192.168.1.10.
Disable your DHCP server.
② Click Advanced > Wireless > Basic to check the SSID and Channel. They should be the same as Router 1’s. If
not, correct them manually. Click Apply/Save to save your settings.
③ Click Advanced > Wireless > Security to check the security mode and wireless key. Verify that they are the
same as Router 1’s. If not, correct them manually. Click Apply/Save to save your settings.
④ Click Advanced > Wireless > Wireless Bridge to configure wireless bridge.
Access Point (Recommended):
Two ways to bridge Router 1 by using Access Point:
a. If you select Enable in Bridge Action field.
To Next Page
Loading...
