Tenda G3

Device Management
- 21 -
Parameter description in the page:
Parameter
Description
WAN ports
Set the number of WAN ports and view RJ45 port status (connection status. The role is
WAN or LAN port). The device enables 2 WAN ports by default. After the number of
WAN ports is modified, the RJ45 port status diagram will also be changed as follows:
indicates that the port connection is normal. indicates that no device is
connected to the port or connection is abnormal.
Connection Type
Router connection method. Three connection methods are described as follows:
 ADSL: Broadband operators such as China Telecom and China Unicom provide a
PPPoE username and password. When surfing the Internet without using the
router, you need to perform dial-up access on the computer.
 Dynamic IP: Broadband operators such as China Telecom and China Unicom do
not provide any Internet access information. When surfing the Internet without
using the router, you can surf the Internet by connecting the computer with a
broadband network cable.
 Static IP: Broadband operators such as China Telecom and China Unicom a fixed IP
address. When surfing the Internet without using the router, you need to set a
static IP address on the computer for Internet access.
PPPoE Username and
PPPoE Password
Valid when the connection method is ADSL. Consult your broadband operator.
IP Address, Subnet
Mask, Default
Gateway, and
Preferred/Alternate
DNS
Valid when the connection method is Static IP. Consult your broadband operator.