51
Application Scenario
An F3 is used to set up a LAN at an apartment and the router must be logged in and managed over the
internet. Assume the public IP address of the router is 102.33.66.88 and the public IP address of the
computer for remote login is 218.88.93.33.
The following figure shows the application scenario.
The computer used to remotely log in to the router web UI must be assigned a public IP address. If it is
assigned a private IP address, use the public IP address of the router to which the computer connects for
remote login. Private IP addresses are not applicable to remote management.
Procedure
Step 1 Choose Administration > Remote Web Management.
Step 2 Select the Enable.
Step 3 Select Custom from the Allow Interent User(s) drop-down list, and enter the WAN IP address
(public IP address) of the computer where remote management is to be performed. In this
example, set it to the WAN IP address of computer 2, which is 218.88.93.33. If you are uncertain
about the IP address of the computer, select Anyone (default value) from the Allow Interent
User(s) drop-down list. In this case, all computers can log in to the router web UI over the
internet.