Tenda P200 - Using the Pair Button for Security; Create Encrypted Private Network

P200 200Mbps PowerLine Mini Adapter
32
Chapter 5 Using the Pair Button
The device provides 128-bit AES encryption method. This section presents
how to use the Pair hardware button to create a secure Powerline network.
Note:
2 or more Tenda Powerline adapters under a single electricity meter will
interconnect to create an unencrypted public network automatically using
the same network name of HomePlugAV.
To create an encrypted private connection between 2 Tenda adapters, do
as follows:
1. Press the Pair button on Adapter 1 for 2-3 seconds and then release it. The
Power LED on the Adapter 1 will start blinking.
2. Within 2 minutes upon releasing adapter 1’s Pair button, press the Pair
button on Adapter 2 for 2-3 seconds and then release it. The Power LED on
the Adapter 2 will start blinking.
3. Observe the two adapters’ LED status. If the Power and PLC LEDs on the
two adapters deliver solid lights, it indicates an encrypted private Powerline
network is successfully created.