P200 200Mbps PowerLine Mini Adapter
34
As displayed above, the 3 adapters have interconnected on a private
Powerline network. If you want to disconnect Adapter 3 from the network,
then press the Pair button on Adapter 3 for 9-11 seconds and then release it.
The Power LED on Adapter 3 goes off and then light up again. The adapter
will restart automatically and leave Network 1.
Note:
When adding a new adapter to an encrypted powerline network, make sure its
network name is exactly same to the existing network’s and “Encrypt” is enabled on
it. You must go to the utility to change such adapter’s network name and enable
“Encrypt” only. Pressing the Pair button will not help in this case.
To Next Page
Loading...
