Tenda PH10 - Device Indicators and Controls

2
1.3 LED Indicators, Port and Buttons
LED Indicator
LED
Color
Status
Description
*Available
only on
PA7
Green
Solid on
The WiFi is enabled.
Blinking
The device is performing WiFi cloning.
/
Off
The WiFi is disabled.
Green
Solid on
The device is connected to a powerline network, and in good
condition.
Blinking
The device is pairing with another powerline device.
Red
Solid on
The powerline network connection is poor. Try changing another wall
receptacle until the light turns green.
/
Off
 The device fails to pair with another powerline device.
 The device works in power saving mode.
Green
Solid on
The device is powered on, and works properly.
Blinking
The device works in power saving mode.
/
Off
The device is not powered on, or cannot be started.
Port & Button
Button
Description
Wi-Fi
*Available only
on PA7
 When the LED indicator is on, press it (within 3 seconds) to perform WiFi cloning.
 If the LED indicator is off after the device is powered on for about 20 seconds, pressing
it (within 3 seconds) can enable WiFi.
 When the LED indicator is on, hold it down for 6 seconds to disable WiFi.
Pair
 After the device is powered on for about 20 seconds, press it (within 3 seconds) to pair with
another powerline device.
 After the device is powered on for about 20 seconds, hold down this button for 6 seconds
to restore factory settings.