7
3 Pairing the Devices
PH10 can automatically set up a powerline network with other HomePlug AV/Homeplug AV2 compliant
powerline adapters in the same electrical circuit. If you only want specified powerline adapters to set up a secure
powerline network, or set up several different powerline networks under the same electrical circuit, you can use
the Pair button.
3.1 Setting up a Secure Powerline Network.
You can pair P3 and PA7 using the Pair button to set up a secure powerline network.
Step 1 Press the Pair button on P3, and the LED starts blinking.
Step 2 Within two minutes after step 1, press the Pair button on PA7, and the LED starts blinking.
Step 3 Wait until the LEDs on both P3 and PA7 turn solid on.
It indicates that P3 and PA7 have paired with each other successfully.
--End
3.2 Adding More Powerline Adapters to a Secure
Powerline Network
You can add more powerline adapters to an existing powerline network, only two powerline adapters can pair
with each other at a time.
Step 1 Press the Pair button on the newly added powerline adapter, and the LED starts blinking.
Step 2 Within two minutes after step 1, press the Pair button on P3 or PA7, and the LED starts
blinking.
Step 3 Wait until the LEDs on both the new added powerline adapter and P3 or PA7 turn solid on.
It indicates that the new added powerline adapter have added to the powerline network
successfully.
To Next Page
Loading...
