Tenda TEG1016D User Manual

5
Remarks: 1000Mbps port may be flashing together with Link/Act when it
transfers datum.
Before Connecting to the Network
TEG1016D/1024D supports the desktop and rack-mountable installation.
Before connecting to the network, please pay attention to the following
instructions:
¾ Don’t put heavy articles on the Switch.
¾ Power sockets and equipments should be within 1.5 meters of the
Switch.
¾ Check power supply to confirm the safe connection.
¾ Make sure there’s adequate space for proper heat dissipation and
adequate ventilation around the Switch.
¾ When installing the Switch on a level surface, attach the rubber feet to
the bottom of the device in case of being scratched or scratching other
surfaces.
Rack-mountable Installation
The TEG1016D/1024D Gigabit Ethernet Switch also supports rack-mount. If
you want to install the device in this way, please refer to the following
instructions to set up.

Tenda TEG1016D Specifications

General

MAC address table	8000 entries
Store-and-forward	Yes
Maximum data transfer rate	32 Gbit/s
Supported data transfer rates	10/100/1000 Mbps
Wi-Fi	No
Size (imperial)	11 \
Power requirements	100 - 240 V
Networking features	Ethernet, Fast Ethernet, Gigabit Ethernet
Connectivity technology	Wired
Networking standards	IEEE 802.3, IEEE 802.3ab, IEEE 802.3u, IEEE 802.3x
Copper ethernet cabling technology	1000Base-T, 100Base-TX, 10Base-T
Switch type	Unmanaged
Power connector	DC-in jack
Basic switching RJ-45 Ethernet ports quantity	16
Certification	QA
Product color	Blue
Power consumption (typical)	25 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 90 %
Harmonized System (HS) code	85176990