IB 9012828 (10- 2014) 1
INSTRUCTION BULLETIN
No. 9012828
Machine: M20 / T20
(Gas / LPG only)
Published: 10- 2014
Rev. 00
NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place the
Parts List in the appropriate place in the machine manual for future
reference. Retaining the Parts List will make it easier to reorder
individual parts an d will save the cost of ordering an entire kit.
NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials.
Installation instructions for kit number 9012811
SYNOPSIS:
This kit contains the parts needed to install a radiator screen kit on M20 / T20 machines.
(Gas / LPG machines only).
Tennant NA: M20 (Serial Numbers 000000- 003038), T20 (Serial Numbers 000000- 002092)
Tennant CE: M20 (Serial Numbers 0000- 0195), T20 (Serial Numbers 0000- 0188)
SPECIAL TOOLS / CONSIDERATIONS: NONE
(Estimated time to complete: 8 hours)
When assembling / disassembling hydraulic components:
1. Thoroughly clean outside of hydraulic components before
disconnecting hydraulic hoses or fittings
and flush hoses and fittings with air, solvent, or hydraulic fluid and cap disconnected hoses or open
ports to prevent contaminants from entering system.
2. Mark hydraulic hoses with locations of where they are attached. Markings make it easier to reconnect
hoses to proper locations.
3. Discard all hydraulic fluid drained from the system. Use only new approved hydraulic fluid to replenish
hydraulic reservoir. Hydraulic fluid is potentially dangerous to the environment. Obey all federal, state,
and local laws/regulations governing the disposal of environmentally hazardous materials when
disposing hydraulic fluid.
PROTECT THE ENVIRONMENT
Please dispose of pac kaging mat er ials, used machine component s
such as batt er ies and fluids in an environment ally s af e way accor ding
to local wast e disposal regulat ions .
Always remember to recycle.
To Next Page
Need help?
General
