Tennant t500 - User Manual

Other manuals for Tennant t500

Service Information Manual146 pages

Questions and Answers

E
Elizabeth HudsonJul 27, 2025
Why is my Tennant t500 Scrubber leaving water behind?
- D
  Douglas PowellJul 27, 2025
  If your Tennant Scrubber leaves water behind, consider the following: * The recovery tank may be full or have excessive foam. Drain the recovery tank. * The drain hose cap may be loose, or the flow control valve is open. Replace the cap or close the valve. * The squeegee blades could be worn. Rotate or replace them. * The drip trap (Squeegee assembly) might be clogged. Remove the cover and clean it. * The squeegee assembly may be clogged. Clean the squeegee assembly. * The vacuum hose connection could be loose. Secure it. * The vacuum hose may be clogged. Flush the vacuum hose. * The float shut-off screen in the recovery tank may be clogged. Clean the screen. * The recovery tank lid may not be completely closed. Check the lid for obstructions.
R
Richard RosarioJul 31, 2025
What to do if my Tennant t500 machine will not operate?
- R
  Raymond BryantJul 31, 2025
  If your Tennant Scrubber won't operate, there are several possible causes: * The emergency shut-off button may be activated. Turn the button to reset it. * The batteries might be discharged. Recharge them. * Loose battery cables can prevent operation. Tighten any loose cables. * The batteries may be faulty and need replacing. * A circuit breaker might have tripped. Reset the circuit breaker.
M
Mario FergusonAug 6, 2025
Why is the on-board battery charger of my Tennant t500 Scrubber not working?
- A
  Andrea LopezAug 6, 2025
  If the on-board battery charger of your Tennant Scrubber won't operate: * The plug may not be connected to the power supply. Check the plug connection. * The batteries may be over discharged. Replace the batteries. * The charger itself may be faulty. Replace the charger. * The power supply cord may be faulty. Replace the power supply cord.
R
Robert ShortAug 11, 2025
How to improve the scrubbing performance of my Tennant t500 Scrubber?
- J
  Jeffrey FieldsAug 11, 2025
  If your Tennant Scrubber's scrubbing performance is poor: * Debris may be caught in the brush or pad. Remove any debris. * The brush or pad might be worn. Replace the brush or pad. * The brush pressure may be incorrect. Adjust the brush pressure. * You may be using the wrong brush or pad type. Use the correct brush or pad for the application. * The battery charge may be low. Recharge the batteries.
A
ayoungAug 16, 2025
What to do if my Tennant Scrubber has little or no solution flow?
- A
  albertbrownAug 16, 2025
  If your Tennant Scrubber has little or no solution flow: * The solution tank may be empty. Refill the solution tank. * The solution flow rate may be set too low. Increase the solution flow rate. * The solution tank filter might be clogged. Clean the filter.
D
David BrownAug 20, 2025
Why does my Tennant Scrubber have a short run time?
- E
  Edward JimenezAug 21, 2025
  If your Tennant Scrubber has a short run time: * The battery charge may be low. Charge the batteries. * The battery may be defective or at the end of its life. Replace the batteries.