IB 9015637 (03- 2020) 1
INSTRUCTION BULLETIN
No. 9015637
Mach i n e: M20/T20/
M30/ M17
Pu b l i sh ed : 03 - 2020
Rev. 01
NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place the
Parts List in the appropriate place in the machine manual for future
reference. Retaining the Parts List will make it easier to reorder
individual p arts and will save th e cost of ordering an entire kit.
NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials.
Installation instructions for kit number 9015633/9015042
SYNOPSIS:
This kit contains the parts needed to replace Pro- Panel assembly on M17/M20/M30/T20 machines.
Please follow step-by-step instructions.
SPECIAL TOOLS / CONSIDERATIONS: NONE
(Estimated time to complete: 45- 60 minutes)
PROTECT THE ENVIRONMENT
Please dispose of packaging mat erials , used machine component s
such as bat t er ies and f luids in an envir onment ally saf e way according
to local was t e disposal regulat ions.
Always remember t o recycle.
PREPARATION (M20/M30/T20 ONLY):
1. If the pod assembly on machine is operable,
connect service computer to the pod, turn the
key to the ON position, but do not start the
machine, start the Capture application, and
note machine settings. The new pod
assembly (1) will need to be configured to the
same settings.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, set parking brake, and remove key.
2. Disconnect the battery cables from the
battery.
W ARNING: Always disconnect battery
cables from machine before working on
electrical components.
3. Open the front shroud to access the steering
mechanism components.
INST ALLATION (M20/M30/T20 ONLY):
1. Disconnect the pod cables from the main wire
harness. (Fig. 1)
FIG. 1
To Next Page
Need help?
General
