Z
zgaySep 5, 2025
Why Tennant T300 brush motor will not operate?
- TtannercodySep 6, 2025
If the brush motor on your Tennant Scrubber isn't running, reset the circuit breaker if it has tripped (T300e).
To Next PageTo Next PageWhy Tennant T300 brush motor will not operate?
If the brush motor on your Tennant Scrubber isn't running, reset the circuit breaker if it has tripped (T300e).
Why T300 Tennant Scrubber severe environment tank does not dispense detergent?
If the severe environment tank on your T300 Tennant Scrubber isn't dispensing detergent, refill the tank.
What to do if my Tennant Scrubber shows an E-Stop activate fault?
If the Tennant Scrubber displays an E-Stop activate fault, first turn the machine off and then press and reset the E-Stop button. Turn the machine back on. If the fault continues, inspect the harness connections between the E-Stop and the control module. You may need to replace or repair the harness or replace the E-Stop button itself. This could be due to the E-Stop being pressed, a disconnected i-Drive connector, a disconnected i-Drive power wire, or issues with the scrub controller board connector.
What to do if my Tennant Scrubber displays an actuator open warning?
If the Tennant Scrubber displays an actuator open warning, check the connectors and connector pins. This issue is usually caused by wiring, connector, or control board problems related to the actuator.
Why does my Tennant T300 Scrubber show a Scrub Motor Open Warning?
If the Tennant Scrubber shows a Scrub Motor Open Warning, check the connections. The board receives power from the key switch and battery. If the connections are in good condition, replace the control board. Possible causes include wiring, connector, or control board issues on the scrub motor; the J10 connector on the scrub controller board being unplugged; the scrub controller board power being disconnected; a defective or blown scrub controller inline power fuse; or a problem with the scrub controller board.
What to do if my Tennant Floor Machine will not start?
If your Tennant Floor Machine isn't operating, start by checking if the emergency stop button is activated and turn the button to reset it. Other possible causes include discharged batteries (recharge them), loose battery cables (tighten them), or faulty batteries (replace them). Also, check if a circuit breaker has tripped and reset it if necessary.
General| Solution Tank Capacity | 11 gal / 42 L |
|---|---|
| Power Source | Battery |
| Machine Type | Walk-Behind |
| Battery Voltage | 24 V |
| Sound Level | 68 dBA |
| Cleaning Path | 17 in / 430 mm |
