▪ When properly adjusted, the saddle should be at hip height.
▪ Check and ensure that the front wheel quick release, handlebar, brakes,
pedals, and other related parts of the e-bike are properly fastened before
you start to ride.
▪ The brake settings vary by country / region. Check which brake lever acts
on which brake first, and if it does not comply with your habits, we recommend
that you ask an expert to change the settings so that you can accurately brake
the front and rear wheels if an emergency occurs while you’re riding. If you
encounter any problems while riding, please brake first ( please brake both
wheels at the same time to stop within the shortest possible distance ).
▪ Check the steering; the steering has a crucial impact on braking and
riding safety.
▪ We recommend that you purchase relevant insurance for bikes
or e-bike
riding in your area. This way you can contact your insurance
company or
agency promptly to get adequate protection in the event of an accident.
▪ When charging your e-bike:
1. Charge the bike indoors and keep it away from direct sunlight, ain, or
snow.
2. Use only the TENWAYS charger to charge the bike.
3. Ensure a proper ambient temperature. The best ambient temperature for
the charger is between 20°C and 25°C. A lower temperature may lead to
insucient charging, while a higher temperature may lead to overcharging.
4. It is recommended to remove the charger immediately after the bike is
fully charged to avoid overcharging the battery.
5. When using the charger to charge the battery, connect the charger
to the
battery charging port, and then connect the charger to the power socket.
When removing the charger, disconnect the
charger from the power socket,
and then disconnect the charger
from the battery charging port.
▪ Check the tire pressure by hand or with a gauge and ensure the pressure
is within the range of 40 - 65 PSI or 2.8 - 4.5 bar.
▪ Check that the transmission chain is correctly hung on the chainring
and freewheel ( the chain may drop outwards during transportation due
to the existence of a rear derailleur ). Before riding your e-bike on roads,
ensure compliance withlocal riding
regulations, for example those
governing riding equipment, control
lights, and reflectors. Make sure that
you wear the correct protective
equipment. Always wear a helmet and
ensure that your vision is clear.
02.
BEFORE YOUR FIRST RIDE
Charge the battery to 100% before your first ride.
032 Bike usage
To Next Page
Loading...
