Before riding, check that screws in the following key parts are properly
tightened:
1. Screws between the stem and the front fork
2. Screws between the handlebar and the stem
3. Screws between the brake lever and the handlebar
4. Screws between the brake clamps and frame or front fork
5. Screws between the discs and bottom brackets
Use the tools provided to tighten any loose screws.
After all screws are properly tightened before the first ride, check that they
have maintained the same fastening performance after 200 km of riding.
Following the initial 200 km, check the screws after every 1000 km of riding.
It is recommended to check the fastening performance of screws
at every
600 km if you usually ride under complex road conditions.
Daily inspection
Daily cleaning
▪ Use a rag or large brush to clean off dust when there is not much mud on
your e-bike.
▪ When there is a lot of mud on your e-bike, use a brush dipped into soapy water
to wash it off, rinse it with a little clean water, then dry it with a soft cloth.
▪ Apply 2 to 3 drops of lubricant at each link turning point after the chain is
cleaned and dried.
▪ Check the wear degree of the brake blocks after you have cleaned them to see if
they can ensure normal braking. Replace them promptly if they are seriously worn.
▪ It is recommended to clean the e-bike after you ride it for about 200 km. You
need to clean the bike first before you put it into storage if you plan to not ride
for a long period of time.
03.
BEFORE YOUR FIRST RIDE
033 Bike usage
To Next Page
Loading...
