Transmitter Status Screens - Cycle through status screens or return from the menu by pressing
the Menu joystick (G).
• Main Status Screen - This screen displays the status of the wireless receiver, along with the current
video resolution, frequency, link quality (if connected).
• Info Screen - Displays the current voltage and internal temperature of the unit.
• HDMI Status Screen - Displays the status of your HDMI signal.
Menu Operation - Launch, then navigate through the menu with the Menu joystick (G), or from the
Ranger App (pg. 10).
• Wireless Settings - Configure the transmitter’s wireless settings.
� Enable Broadcast Mode - Broadcast Mode enables Ranger to extend its range when used with
the Array Antenna, and to transmit to an unlimited number of receivers (non-DFS channels only).
� Enable Fixed Frequency - Fixed Frequency Mode allows your Ranger to designate a specific
non-DFS frequency range for use, providing a stronger connection in dicult environments.
� Allow Licensed Channel - Enable or disable Licensed Channel selection under the Frequencies.
� Bandwidth - Choose between 20MHz and 40MHz bandwidth options
� Frequencies - Select which frequency to use.
� Video Quality - Select a Video Quality setting to modify or balance the range and reliability of your
signal. Select Longer Distance for situations where other sources of interference might be
present, or Better Quality to reduce artifacts during complex, high-contrast scenes.
9
TRANSMITTER MENU
To Next Page
Loading...
