• Pair - Pair your transmitter with another receiver. Once Pairing is activated on the transmitter,
activate Pairing on the receiver.
• Unpair - Unpair your transmitter and receiver.
• HDMI/SDI Out Format - Select the video output format. You can choose to match the video source
resolution by selecting Same as Input, or choose from the resolutions listed. If using Ranger receiver
with a recorder or monitor that is sensitive to video signal changes, choose Continuous Output to
ensure the signal stays constant even if the link is interrupted. Note that this adds a small delay to the
video output.
• HDMI Settings - Select the HDMI color output.
• 3D LUT Settings - Select and apply a specific look.
• Test Pattern - Select a video format to output a test pattern. Remove the test pattern by pressing left
on the Menu joystick.
• Audio Settings - Configure Ranger’s Audio settings. If Beep on REC is activated, you will hear a short
tone whenever the camera begins or stops recording. The Mute Settings allow you to select between
completely muting the audio, not muting the audio, or muting the audio while recording.
• Bluetooth - Enable or disable bluetooth communication.
• Video OSD Settings - Choose when to display the OSD. By default, the OSD is displayed when no
video is received. Selecting the Never show option disables the OSD. The Show when operating
option hides the OSD until it is activated by the joystick. Selecting Show when no video will display
the OSD when there is no video feed, and will hide OSD when video appears (default). If Always show
OSD is selected, the OSD will always be displayed unless temporarily deactivated by the Menu joystick.
• Display Settings - Use the Display Settings to control the OLED display operation. By default, the
12
To Next Page
Loading...
