August 2016
3 - 4 AL4 • AL4000 Part No. 218567
Section 3 • Scheduled Maintenance Procedures
Checklist D Y N R
Perform every 1500 hours:
D-1 Engine maintenance -
Kubota models
Perform every 8000 hours:
D-2 Generator -
Leroy Somer Models
Perform annually:
D-3 Coupler
Checklist E Y N R
E-1 Cable
Perform every 2000 hours:
E-2 Engine maintenance
Perform every 3000 hours:
E-3 Engine maintenance
Perform every 10,000 hours:
E-4 Generator -
Marathon Models
Perform every 20,000 hours:
E-5 Generator -
Leroy Somer Models
Perform every 30,000 hours:
E-6 Generator -
Leroy Somer Models
Comments
Instructions
• Make copies of this report to use for
each inspection.
• Select the appropriate checklist(s) for
the type of inspection to be performed.
Daily or 8 hours
Inspection: A
Quarterly or 250 hours
Inspection: A+B
Semi-annually or
500 hours
Inspection: A+B+C
Annually or
1000 hours
Inspection: A+B+C+D
Two year or
2000 hours
Inspection: A+B+C+D+E
• Place a check in the appropriate box
after each inspection procedure is
completed.
• Use the step-by-step procedures in
this section to learn how to perform
these inspections.
• If any inspection receives an “N”, tag
and remove the machine from service,
repair and re-inspect it. After repair,
place a check in the “R” box.
Legend
Y = yes, acceptable
N = no, remove from service
R = repaired
Model
Serial number
Date
Hour meter
Machine owner
Inspected by (print)
Inspector signature
Inspector title
Inspector company
MAINTENANCE INSPECTION REPORT
To Next Page
