August 2016
3 - 12 AL4 • AL4000 Part No. 218567
Section 3 • Scheduled Maintenance Procedures
5 Visually inspect the winch cable for the
following:
• nicks (partial strand cut through)
• kinks in the cable (permanent bends)
• weld spatter
Result: Nicks, kinks in the cable or weld spatter
are found. The cable must immediately be
replaced.
6 Visually inspect the winch cable for the
following:
• crushed spot on the cable
Result: A crushed spot on the cable measuring
125% of the cable diameter or more is found
OR there is a broken wire at the crush point.
The cable must immediately be replaced.
7 Wind the cable onto the winch, ensuring that
the cable is correctly installed onto each of the
pulleys.
CHECKLIST A PROCEDURES
A-14
Perform Engine Maintenance -
Kubota Models
Engine specifi cations require that this procedure
be performed every 100 hours.
• Clean air fi lter
• Clean fuel fi lter
• Inspect fan belt
Required maintenance procedures and additional
engine information is available in the
Kubota D1105 Operator's Manual
(Kubota part number 16622-89166) OR the
Kubota D1105 Operator's Manual
Genie part number 131379
To Next Page
Loading...
