Section 3 • Scheduled Maintenance ProceduresAugust 2016
Part No. 218567 AL4 • AL4000 3 - 11
A-12
Perform Engine Maintenance -
Kubota Models
Engine specifi cations require that this one time
procedure be performed after the fi rst 50 hours of
operation.
• Change engine oil
• Replace oil fi lter
Required maintenance procedures and additional
engine information is available in the
Kubota D1105 Operator's Manual
(Kubota part number 16622-89166) OR the
Kubota D1105 Operator's Manual
Genie part number 131379
A-13
Inspect the Cable and
Cable Pulleys
Terex specifi cations require that this procedure be
performed monthly.
Detection of damage to the cable or pulleys is
essential for safe machine operation. An unsafe
working condition exists if these components are
damaged and do not operate smoothly. Regular
inspection of this system allows the inspector to
identify changes in the operating condition that
may indicate damage.
1 Visually inspect the winch cable pulleys for the
following:
• broken or damaged pulleys
• unusual or excessive pulley wear
Result: A pulley is broken or damaged, or
shows unusual or excessive pulley wear. The
pulley must immediately be replaced.
2 Put on protective leather gloves and eye wear.
3 Fully unwind the cable from the winch.
4 Wearing leather gloves, run a hand up and
down a length of the cable, inspecting the cable
and components for the following:
• frayed or broken wire strands
Result: In any given one-foot of cable length
there are 4 or more broken wires on any 2 or
more strands. The cable must immediately be
replaced.
CHECKLIST A PROCEDURES
To Next Page
Loading...
