November 2006
Part No. 833002 Rev A AL4000 Light Tower 15
SETUP
H. Raising the tower as follows:
1. Remove the tower travel locking pin from the cradle at the rear of the cabinet.
2. Remove the tower locking pin from the tower base. Using the lower pivot winch, raise
the tower to the vertical position. Reinsert the tower locking pin into the tower base.
If there is any difficulty in tilting the boom vertically, check the
tailhook and hook. The tailhook may need to be released.
BEWARE OF PINCH POINTS WHEN ERECTING OR STOW-
ING THE TELESCOPING TOWER. A LOSS OF DIGITS OR
LIMBS MAY RESULT FROM UNSAFE PRACTICES.
Do not attempt to lean the tower down when it is extended.
Serious damage may occur.
WHEN RAISING THE BOOM, MAKE SURE THE BOOM
WIRING DOES NOT BECOME ENTANGLED.
To Next Page
Loading...
Need help?
General