November 2006
8 AL4000 Light Tower Part No. 833002 Rev A
GENERAL SAFETY
EXHAUST GASES ARE TOXIC. DO NOT USE INDOORS
UNLESS PROPERLY VENTILATED OR AN EXHAUST
SCRUBBER IS USED.
Check exhaust system regularly for leaks and ensure that the exhaust manifolds are secure and
not warped.
Make sure the unit is well ventilated.
ELECTRICAL SAFETY
This equipment utilizes high voltage circuits. Always exercise extreme caution when trouble
shooting or repairing any electrical circuit.
The electrical circuits in this light tower complete their paths back to the generator within the
equipment. The neutral conductor at the generator is bonded to the equipment frame. Ground
wires within the system are also bonded to the equipment frame.
Always ground the unit when possible. Consult local electrical codes for grounding
instructions.
A grounding lug has been added to the trailer frame for your convenience.
Disconnect electrical power and turn off engine before removing protective covers on high
voltage electrical enclosures.
Beware of a cut or damaged power cord. Have a qualified electrician replace immediately.
When troubleshooting indicates a malfunction in the high voltage AC system, pass the task to a
qualified and trained electrician.
DO NOT TOUCH HOT PARTS
The exhaust manifold and tail pipe are very hot. Parts of the engine are also hot. Use protective
gloves when handling hot parts.
The light fixtures become very hot during operations. To avoid burns, always allow any fixture to
cool before handling.
To Next Page
Loading...
Need help?
General