9011-6
57
REMOVAL AND INSTALLATION OF THE HYDRAULIC RESERVOIR
1. Park the machine on a level surface.
2. Raise the loader and lock the support strut to
hold the machine.
3.Releasethehydraulicsystempressure
4. Drain the hydraulic reservoir (1).
5. Open the hood.
6.Remove the grille.
7.Remove the front coupling.
8. Remove the split pins (2) and washers (3) from
the support (4).
9. Loosen the hose clips (5) and (6) and disconnect
the hydraulic hoses (7) and (8) from the hydraulic
reservoir (1). Put caps on the open ends of the
hydraulic hoses and the hydraulic reservoir.
10. Loosen and remove the bolts (9), washers (10)
and disconnect the manifold (11) and O-ring (12)
from the hydraulic pump (13).
NOTE :
when installing , install a new O-ring (13) in
the manifold (11).
11. If fitted, disconnect the return pipe (14) from the
filler (15). Fit the blanking caps to both
connections.
12. Support the hydraulic reservoir (1) on a suitable
trestle.
13. Remove the nuts (16), washers (17) and (19)
and bolt (18).
14. Carefully, remove the hydraulic reservoir (1) from
the machine.
15. Only carry out 16 through 21 if you replace the
hydraulic reservoir (1).
WARNING:
The hydraulic reservoir is very
heavy. Get help to remove the hydraulic
reservoir from the machine.
!
16. Loosen the hose clip (20) and remove the
manifold (11) and hose (21) from the hydraulic
reservoir.
17. Remove the bolts (22), O-rings (23) and remove
the level indicator (24) from the hydraulic
reservoir (1). Remove the O-rings (25).
NOTE :
When installing, install new O-rings (23) and
(25).
18. Remove the bolts (26) and washers (27) from the
filler (15).
19. Remove the filler (15) from the hydraulic
reservoir (1).
20. Remove the seal (28).
NOTE :
When assembling, install a new seal (28).
21. Unscrew the suction strainer (29) and remove it
from the hydraulic reservoir (1).
NOTE :
The installation of the hydraulic reservoir is in
the reverse order from that removal.
NOTE :
After installation, start the engine and
operate the hydraulic functions of the machine. Make
sure the hydraulic components and hoses which have
been disturbed do not leak. check the oil level in the
hydraulic reservoir, top up if necessary.
To Next Page
Loading...