Part No. 57.0009.0607 GTH 4016 R - GTH 4018 R - GTH-5021 R 71
Road or site transfer
When travelling on public roads, strictly obey the
local or national road traffic regulations.
Before traveling on public roads, ensure the following
precautions are taken:
• Start the engine.
• Align the rear wheels with the chassis.
• Lock the slewing upper structure with the locking
pin.
• Stow the floating forks as shown below
With the floating forks tilted back, do not move the
fork tilting cylinder as the machine could suffer from
damage.
• Retract and lower the boom.
• Set the Job-site/Road/Platform selector to “Road
mode”.
• Make sure that lights, horn and turn signals are
in working order.
• The drive speed of the machine will depend on
the engine rpm, and the gear selected.
Driving on public loads is only allowed with an
unloaded machine. Do not use the machine to
tow trailers.
Operating Instructions
Engine Condition Indicator
If the DPF Alert indicator light and/or the Engine
Critical Fault indicator light switches on, contact
service personnel.
After Each Use
1 Select a suitable parking location—firm level
surface, clear of obstruction and traffic.
2 Retract the outriggers.
3 Retract and lower the boom to the stowed
position.
4 Move the transmission control lever to neutral.
5 Set the parking brake.
6 Set the Slewing upper structure locking pin
7 Turn the key switch to the off position and
remove the key to secure from unauthorized
use.
To Next Page
Loading...
Need help?
General
