Care and Maintenance 7
97/112TL160
Operating Manual 12.9.08 Version 1.0
7.8.14.2 Differential of rear axle with
transmission
Checking the axle oil level
• Park the machine on level ground.
• Remove the inspection-filling plugs (74/1).
• Check if the oil is up to the edge of the inspection-
filling hole.
• Top up oil if required.
• Carefully close the inspection-filling plugs.
Changing axle oil
• Park the machine on level ground.
• Clean the area around the inspection-filling plugs
(74/1) and drain plugs (74/2).
• Open the inspection-filling plugs (74/1).
• Open the drain plugs (74/2) on the differential and
brake housings and drain oil.
• Flush out the axle if necessary.
• Carefully close the drain plugs.
• Pour in oil using the inspection-filling hole until oil
escapes from the other inspection-filling hole.
• Carefully
close the inspection-filling plugs.
Checking the transmission oil level
• Park the machine on level ground.
• Remove the inspection plug (75/1).
• Check if the oil is up to the edge of the inspection
hole.
• Top up oil if required.
• Carefully close the inspection plug.
Fig. 74 Checking / replacing the rear axle oil.
Attention
• Collect the waste oil in a suitable container
and dispose of in compliance with
regulations.
Fig. 75 Checking the transmission oil
To Next Page
