Care and Maintenance7
98/112 TL160
Operating Manual 12.9.08 Version 1.0
Replacing the transmission oil
• Park the machine on level ground.
• Clean the area around the inspection, filling (76/1)
and drain plugs (76/2).
• Open the inspection-filling plug (76/1).
• Open the drain plugs (76/2) on the differential and
brake housings and drain oil.
• Flush out the axle if necessary.
• Carefully close the drain plugs.
• Pour in oil using the filling hole until oil escapes
from the other inspection hole.
• Carefully close the inspection-filling plug (76/1).
Fig. 76 Replacing the transmission oil
Attention
• Collect the waste oil in a suitable container
and dispose of in compliance with
regulations.
To Next Page
