Tescom ER3000 - Analog Setpoint Source

4. Installation 19
4.5.2 Analog Setpoint Source
Check to ensure that the analog setpoint voltage/current select jumper, J5:1, is
installed for 4-20mA or removed for 1-5V operation. There is no jumper on the
0-10V external feedback models. Figure 6 and Figure 7 show how to provide a
4-20mA analog setpoint from a PC D/A card or a PLC D/A module.
Figure 6: Passive PC or PLC D/A Card Analog Setpoint (4-20mA)
NOTE: Wire power as shown in figures 2 & 3
Figure 7: Active PC or PLC D/A Card Analog Setpoint (4-20mA, 1-5V, 0-10V)
NOTE: Wire power as shown in figures 2 & 3