10
Figure 3-2 Connection method of output for NEOLINE 1000(XL)～NEOLINE 3000(XL)
Apart from using the socket for output, NEOLINE 3000(XL) has the terminal block
available for output as well. The wring configuration is shown in the following diagram.
1) Remove the small cover of the terminal block;
2) Use AWG14 (2.1mm
2
) wires for wiring configuration;
3) Upon completion of the wiring configuration, please check whether the wires are securely
affixed;
4) Put back the small cover to the rear panel.
To Next Page
Loading...
