STEP 4: Sizing and Routing Conductor Wires
Pull excess wire first, then cut to length. Use a wire stripper to cut each conductor wire appropriately based
on entry point and position. Attach the conduit/fittings and route each conductor wire into the wirebox so it
lands in the correct terminal.
NOTE: Insulation wire colors may vary based on market.
For Top Wire Entry
Wire lengths/proportions shown are not to scale.
For Bottom (1), Rear Left (2), or Rear Right (3) Wire Entry
Wire lengths/proportions shown are not to scale.
INSTALLATION STEPS
24Gen 3 Wall Connector Manual
To Next Page
Loading...
