Post-installation testing
10
Post-installation testing
Confirming a successful
installation
Apply utility power and observe that only
the green READY light illuminates.
Two “Charge Test” buttons on the PC
board (arrowed in illustration) simulate
connection to a vehicle.
Push both buttons at the same time and
verify that the contactor closes, and the
amber CHARGING light illuminates.
If a vehicle is available, connect the Home
Connector to the vehicle and verify that
the contactor closes, and the amber
CHARGING light illuminates.
Once a successful installation has been
confirmed, close the Home Connector’s
enclosure door and secure the latch.
Reinsert the two Torx screws on the
left-hand side and hand tighten them with
a T15 Torx L driver until snug.
ClipperCreek, Inc.
READY
CHARGE
PROTECT
SERVICE
Home Connector Users Manual.book Page 10 Monday, April 26, 2010 12:38 PM
To Next Page
Loading...
