Mobile Connector Component Overview
1. Adapter
2. Handle
3. Button on handle
4. Status lights
5. Mobile Connector controller
6. Cable
Specifications
Use only a 120 volt, 208 volt or 240 volt AC supply, 50/60 hertz wall outlet that has a dedicated
and properly grounded circuit, and is rated for at least 15 amps.
If possible, use a dedicated receptacle with a single socket. If the receptacle has two sockets, do
not plug any other items into the other socket.
The Mobile Connector is 20 feet (6 meters) long. Use an existing outlet or install a new outlet
within approximately 13 feet (4 meters) of the vehicle's charge port and at least 18 inches (45 cm)
above the ground. The charge port is located on the rear driver's side of the vehicle, behind a door
that is part of the rear tail light assembly.
Warning:
Do not use an extension cord, a multi-outlet adapter, a multi-plug, a conversion
plug, or a power strip to plug in the Mobile Connector.
General Information
4
To Next Page
Loading...
