Testboy TV 455 - Standards Applied

®
TV 450/455 Standards applied
12
2.3 Standards applied
The TV 450/455 instruments are manufactured and tested in accordance with the
following regulations:
Electromagnetic compatibility (EMC)
EN 61326 Electrical equipment for measurement, control and laboratory
use – EMC requirements
Class B (Hand-held equipment used in controlled EM environments)
Safety (LVD)
EN 61010-1 Safety requirements for electrical equipment for measurement, control
and laboratory use – Part 1: General requirements
EN 61010-031 Safety requirements for hand-held probe assemblies for electrical
measurement and test
EN 61010-2-032 Safety requirements for electrical equipment for measurement,
control, and laboratory use - Part 2-032: Particular requirements for
hand-held and hand-manipulated current sensors for electrical test
and measurement
Functionality
EN 61557 Electrical safety in low voltage distribution systems up to 1000 V
AC
and 1500 V
AC
– Equipment for testing, measuring or monitoring of
protective measures
Part 1 General requirements
Part 2 Insulation resistance
Part 3 Loop resistance
Part 4 Resistance of earth connection and equipotential
bonding
Part 5 Resistance to earth
Part 6 Residual current devices (RCDs) in TT and TN systems
Part 7.Phase sequence
Part 10 Combined measuring equipment
Other reference standards for testing RCDs
EN 61008 Residual current operated circuit-breakers without integral overcurrent
protection for household and similar uses
EN 61009 Residual current operated circuit-breakers with integral overcurrent
protection for household and similar uses
EN 60364-4-41 Electrical installations of buildings Part 4-41 Protection for safety –
protection against electric shock
EN 60364-5-52 Low-voltage electrical installations – Part 5-52: Selection and erection
of electrical equipment – Wiring systems
BS 7671 IEE Wiring Regulations (17
th
edition)
AS / NZ 3760 In-service safety inspection and testing of electrical equipment
Note about EN and IEC standards:
 Text of this manual contains references to European standards. All standards of
EN 6XXXX (e.g. EN 61010) series are equivalent to IEC standards with the same
number (e.g. IEC 61010) and differ only in amended parts required by European
harmonization procedure.