TESTO 327 - Measurement procedures

Using the product16
2
Start the measurement with the Start function key only when the required
gas pressure of 10mbar (Let by) or 20mbar (tightness) is displayed.
- p
1 displays the start pressure in mbar, p2 displays the actual value in
mbar.
3 After measuring time, the pressure difference is displayed (p2 - p1 on let
by test, p2 - p1 on tightness test).
Option:
Stop the measurement with the Stop function key.
Draught, Diff.-temp., and Diff.-press functions:
1 Start the measurement with the Start function key.
- The current readings are displayed.
2 Stop the measurement with the Stop function key.
3 Transfer the readings to the central Flue gas measurement menu using the
OK function key.
Smoke/Oild and HCT functions:
Recording values with the smoke pump and manual input:
1 Select the value to be changed using / and confirm with the change
function key.
2 Set the value using / and confirm entry with the OK function key.
3 Once all values have been input, select Finish using / .
4 Transfer the readings to the central Flue gas measurement menu using the
OK function key.
The values entered are not shown in the central Flue gas measurement
menu. However, they can be printed out together with the readings from
other functions.
Recording values with the smoke tester testo 308 and wireless transfer:
- The testo 308 must be in data transfer mode ( lights up).
1 Press function key t308 .
- The values recorded by the smoke tester are transferred.
2 Once all values have been input, select Finish using / .
3 Transfer the readings to the central Flue gas measurement menu using the
OK function key.
The values entered are not shown in the central Flue gas measurement
menu. However, they can be printed out together with the readings from
other functions.