2. Intended purpose20
2. Intended purpose
This chapter gives the areas of application for which the
product is intended.
Use the product only for those applications for which it was
designed. Ask testo if you are in any doubt.
The product was designed for the following
tasks/applications:
· Fast and non-destructive evaluation of material moisture
courses in woods and building materials.
Does not replace reference methods such as CM
method or Darr-Wäge (dry-and-weigh) method.
The instrument is not calibratable.
The product must not be used in the following areas:
· Areas at risk of explosion.
Materials subject to electrical voltage.
Electric shock!
If in doubt, check whether the materials are
energized before the measurement (e.g. in the
event of water damage in walls)
To Next Page
Loading...
Need help?
General
