4. Commissioning 23
4. Commissioning
This chapter describes the steps required to commission
the product.
²
Removing the protective film on the display:
iPull the protective film off carefully.
²
Inserting a battery/rechargeable battery:
1 To open the battery compartment on the rear of the
instrument, push the lid of the battery compartment in
the direction of the arrow and remove it.
2 Insert a battery/rechargeable battery (9 V monobloc).
Observe the polarity!
3 To close the battery compartment, replace the lid of
the battery compartment in position and push it
against the direction of the arrow.
5. Operation
This chapter describes the steps that have to be executed
frequently when using the product.
5.1 Switching the instrument
on/off
²
Switching the instrument on:
iPress .
- The current reading is shown
²
Switching the instrument off:
iPress and hold (for approx. 2 s) until the display
goes out.
To Next Page
Loading...
Need help?
General
