5 First steps
27
2. Grip the imager with your left hand. To do this, hold the casing
at the front of the imager (1).
CAUTION
Display may be damaged!
> Do not hold the imager by the fold-out display.
3. Turn your right hand to move the handle to the required
position (2). Press down with your middle and ring finger. To
rotate in the opposite direction, press up with the heel of your
hand.
5.2.4. Attaching a shoulder strap
> Link together shoulder strap click locks and the carrying strap
attached to the imager.
5.2.5. Using a lens case
The lens case (included in the scope of delivery of the
interchangeable lens) is used to protect and transport the
interchangeable lens. It can be attached using the carabiner e.g. to
a belt loop.
To protect against damage to lenses not being used, the
transparent plastic cap must always be attached to the back of the
lens. Make sure that the case zip is properly zipped up.
To Next Page
Loading...
