5 First steps
24
5.1.3. Initial charging of the rechargeable battery
The imager is delivered with a partially charged battery. Fully
charge the battery before use.
> Connect the country-specific adapter required for the existing
mains to the mains unit.
1. Open the cover of the top interface terminal (1).
2. Connect the mains unit to the mains socket (2).
3. Connect the mains plug to a power socket.
- The imager starts automatically.
The rechargeable battery can be recharged with the imager
switched on or off. This has no effect on the time required
to charge the battery.
- Charging of the battery is started.
- The charge status is indicated by the status LED (3):
• LED flashes: charging in process.
• LED lights: battery charged, charging process finished.
4. Fully charge the battery, then disconnect the instrument from
the mains unit.
- After initial charging of the battery, the imager is ready for use.
A desktop charging station (accessory: 0554 8851) can also be
used to charge the battery.
To Next Page
Loading...
Need help?
General
