7 Maintaining the product
131
Pos: 165 /TD/Übersc hriften/7. Produk t instand halten @ 0\mod_11 73789831362_79.doc x @ 397 @ 1 @ 1
7 Maintaining the product
Pos: 166 /TD/Produ kt instand halten/te sto Saveris/War tung @ 9\mod_1309853188816_79. docx @ 81423 @ 3 @ 1
7.1. Maintenance
If possible, create a database backup of the current system
before carrying out any system maintenance, see Testing
the system, page 78.
The stored Saveris base data can only be imported to a
Saveris base with the same firmware status. The memory
capacity of the target base must be larger than or equal to
the source base. For the memory size, see the Select
language window.
Maintenance includes:
• Registering/deregistering components (calibration outside the
current system)
• System reboot
• Firmware and software update
• Changes in alarm management.
The larger a Saveris system, the more important it is to
carry out a random system test after any
maintenance/major intervention or configuration, see
Testing the system, page 78.
Pos: 167 /TD/Produ kt instand halten/te sto Saveris/00 Ersatz von Komponenten @ 0\mod_1188 476464890_79.doc x @ 2909 @ 2 @ 1
7.2. Replacement of components
You can shut down a component – probe, converter or router – at
any time because this is temporarily not in use or to replace it with
a new component, for example, in the event of a defect.
In the event of a replacement of the Saveris base,
a new project must be created. Please contact our
software hotline if required (softwarehotline@testo.de).
Pos: 168 /TD/Produ kt instand halten/te sto Saveris/01 Komponen ten entfernen @ 0\mod_11937 37448921_79.doc x @ 5643 @ 3 @ 1
7.2.1. Deleting components
1. Under Start | All Programs | Testo click on Testo Saveris
Startup Wizard.
- The welcome dialogue of the startup wizard is shown.
To Next Page
Loading...
Need help?
General
