Teuco S01 - Page 20

20
EN
INSTRUCTIONS FOR USE
SOUND FUNCTIONS
CONNECTION OF THE AUDIO SOURCE (BLUETOOTH®)
RESOLUTION OF PROBLEMS
Irregularity encountered Possible cause Solution
Cannot hear the audio.
Lack of electrical power.
Connect electrical power supply.
Contact Technical Assistance.
Speakers not connected. Check connections.
Lack of Bluetooth® connec-
tion.
Check the synchronisation between the
audio source and the amplier
Volume set at minimum of
the audio source.
Increase the volume of the audio
source.
The source does not connect
with the central unit.
The source does not have
the A2DP/AVRCP proto-
cols.
Check that the communication protocol
of the audio source is
compatible with the amplier (refer
to audio device manual). Check for a
rmware update for the device.
Another device is already
connected.
Remove the connecation in use.
The audio output is weak with
little or no bass.
The loudspeakers have
been erroneously connec-
ted.
Check the connection of the loudspe-
akers respecting the sequence descri-
bed in this manual.
The sound is distorted.
The volume of the source
is set at excessive values.
Lower the volume of the audio source.