Teuco S01 - Connection of the Audio Source (Bluetooth)

19
EN
CONNECTION OF THE AUDIO SOURCE (BLUETOOTH®)
INSTRUCTIONS FOR USE
SOUND FUNCTIONS
Follow these steps to carry out the Bluetooth® audio connection between the amplifier and an audio
source equipped with a Bluetooth® A2DP transmission signal:
- Switch on the amplifier (with the loudspeakers connected).
- Switch on the source device and activate the Bluetooth® function.
- If a connection confirmation is requested, digit the pairing code: 0000.
- Play an audio track via the player of the source device.
In the case of source devices such as mobile phones, it is necessary to carry out the synchronisation of
the Bluetooth® devices utilising the device research function.
For further information, refer to the instruction manual of your telephone.
REQUIREMENTS OF THE SOURCE DEVICES:
To function correctly with the amplifier, the source device must have the following characteristics:
- Communication protocol: Bluetooth® 2.1 or previous.
- Profiles: A2DP, AVRCP.
- Band frequency: 2.4 GHz.
- Range: Class 2 - 10m.
- Audio volume control.
TECHNICAL CHARACTERISTICS:
TECHNICAL CHARACTERISTICS
Power source 230Vac 50/60Hz
Power source protection fuse Fuse 5x20, 400 maT 250V
Nominal power output (Left/Right) 10+10 Wrms at 4ohm
Subwoofer nominal power output 20 Wrms at 4ohm
Frequency response 80-20000 Hz
Operating temperature range -10/+50 °C
Operating temperature range -10/+70 °C
Bluetooth® SPECIFICATIONS
Bluetooth® Protocol 2.1
Proles A2DP, AVRCP
Range Class 2 - 10m/33ft
Pairing code 0000