FAQ
www.ti.com
34
SLAU597E–March 2015–Revised January 2018
Submit Documentation Feedback
Copyright © 2015–2018, Texas Instruments Incorporated
MSP432P401R SimpleLink™ Microcontroller LaunchPad™ Development Kit
(MSP
‑
EXP432P401R)
Figure 26. Connect Target
Now run a script to return the device back to factory settings:
Scripts > default > MSP432_Factory_Reset
Figure 27. MSP432_Factory_Reset Script
• These instructions are generally the same for all IDEs, but the exact steps may vary slightly by IDE.
See the following IDE user's guides for additional details:
– Code Composer Studio™ IDE 7.1+ for SimpleLink™ MSP432™ Microcontrollers User's Guide
– ARM® Keil® MDK Version 5 for SimpleLink™ MSP432™ Microcontrollers User's Guide
– IAR Embedded Workbench for ARM 7.x for SimpleLink™ MSP432™ Microcontrollers User's Guide
Q: How do I use the LaunchPad development kit and my Segger J-Link to debug the target externally? It
won't connect to the onboard connector.
A: The Segger J-Link does not come with an adapter for the 10-pin small-pitch ARM connector. The
adapter cable is available from SEGGER or from Digi-Key.
To Next Page
Loading...
