Texas Instruments TI-60 User Manual

CHAPTER 1-7
PROGRAMMING KEYS
unchanged You must either use [2nd [CP] to erase the entire program or
delete the necessary number of program steps
If you attempt to enter a program step that would cause your program to
exceed the current partition setting the calculator automatically leaves the
learn mode and resets the program counter to the start of program memory
<St)
If you are m the process of entenng a program and discover thal you need
more program steps, you can leave the learn mode and repartition the
memory
2. Press rand ] [Part] 0 to display the current setting
3. Preas 2nd [ [Part] and the key representing the number of data
memories you want to keep
4. Press roar to re-enter the learn mode (if desired)
It the calculator automatically left the learn mode while you we'e
entenng a program step, press IWW ifB8T~i o r press (S8T until
you reach the last step in program memory Then continue
programming
If you left the learn mode before reaching the end of program
memory,' the calculator returns to the program step that was
displayed when you left the team mode
Partition the memory for 6 and 12 data memories
Preas Display
IWT !M! 0
2nd [Part] 8 Pt 36 8
[jtnd [Part] <C> Pt 07 C
[*%Cj o
2nd [Part]. gj Pt 07 C
Comments
Clear calculator
Partition lor S data memories and 35
program steps
Partition (Or 12 data memories and 7
program steps
Clear display
Display current partitioning
LAN — Learn Mode Key
Press LAN to enter or to leave the learn mode. In the learn mode, each
keystroke is recorded as a program step Be sure to leave the learn mode
by pressing LRN1 again before you press any keys that are not part of your
program
M-GB

Texas Instruments TI-60 Specifications

General

Brand	Texas Instruments
Model	TI-60
Category	Calculator
Language	English